[First Hit]

Datapages, Inc.Print this page

Use of Seismic Attributes and Acoustic Impedance in 3D Reservoir Modelling: An Example from a Mature GOS Previous HitCarbonateNext Hit Field (Ras Fanar)

By

 Richard D. Vaughan1, Alaa Atef1, Nader El-Outefi1

(1) German Oil & Gas Egypt - GEOGE, Cairo, Egypt

 Discovered in April 1978, Ras Fanar Field in the Gulf of Suez of Egypt has produced approximately 91 MM STB oil, from Middle Miocene coralline algal carbonates which are informally known as the “Nullipore Previous HitFaciesNext Hit” and to a lesser extent the South Gharib Formation. The field lies some 2 Km offshore east of Ras Gharib and produces from a NW-SE trending structural trap bounded by a major fault system to the SW and tilted to the NE. The depositional setting of the reservoir comprises a narrow 4-5 Km wide Previous HitcarbonateNext Hit ramp which extends eastwards from Ras Gharib Field to Ras Fanar Field. In previous interpretations the Previous HitcarbonateNext Hit Nullipore Previous HitFaciesNext Hit was interpreted as eroded and subsequently on-lapped by South Gharib sediments along a single unconformity. The current geological model allows for both lateral and vertical Previous HitfaciesNext Hit transitions between the Nullipore carbonates and South Gharib evaporitic-siliciclastic-Previous HitcarbonateNext Hit units. Several phases of upward-shoaling deposition and erosion are evident. Periods of erosion coincide with high porosity layers within the reservoir resulting from karstification and solution collapse brecciation. Diagenetic overprinting of the original Previous HitfaciesNext Hit was intense therefore a petrophysical-based modelling procedure was adopted.

This paper presents a simple but effective 3D reservoir modelling workflow which used absolute acoustic impedance (AI) data and its relationship to effective porosity as a deterministic 3D modelling parameter (“porosity-Previous HitfaciesNext Hit”) rather than the more traditional Previous HitfaciesNext Hit based approach. Implicit in the modelling workflow was the assumption that the 3D distribution of the resulting “porosity-Previous HitfaciesNext Hit” could be interpreted using a geological model which conformed to a “modern” sequenced-based approach to reservoir zonation and the model-derived vertical and horizontal “porosity-Previous HitfaciesNext Hit” trends were reflected in the actual evaporitic-Previous HitcarbonateNext Hit Previous HitfaciesTop transitions seen in the Gulf of Suez today, as well as nearby outcrop analogues.