[First Hit]

Datapages, Inc.Print this page

Click to article in PDF format.

      

 

Seismic Analysis and Characterization of Previous HitGasNext Hit Previous HitHydratesNext Hit in the Northern Deepwater Gulf of Mexico*

By

Fred Snyder1, Nader Dutta1, Deborah Hutchinson2, Patrick Hart3, Myung Woong Lee4, Brandon Dugan2, Carolyn Ruppel5, Warren Wood6, Richard Coffin7, Robert Evans8, and Emrys Jones9

 

Search and Discovery Article #40137 (2004)

 

*Adapted from expanded abstract prepared for presentation at AAPG Annual Convention, Dallas, Texas, April 18-21, 2004.

 

1Schlumberger Reservoir Services / Data & Consulting Services, Houston, TX ([email protected]); 2USGS, Woods Hole, MA; 3USGS, Menlo Park ([email protected]), CA; 4USGS, Denver, CO; 5Georgia Tech, Atlanta, Georgia; 6NRL, Stennis Space Center, MS; 7NRL, Washington, DC; 8WHOI, Woods Hole, MA; and 9ChevronTexaco, Houston, TX.

 

Abstract 

The deepwater Gulf of Mexico contains many known hydrate environments. Complex lithostratigraphy and active salt movement create complicated thermal regimes and fluid chemistry. These in turn affect hydrate formation and distribution. In an effort to study and eventually test different hydrate settings, two separate areas were selected for review by a multi-disciplinary team. Reprocessed 3D and high-resolution 2D multichannel seismic data were analyzed over Keathley Canyon block 195 and Atwater Valley block 14, both of which are in water depths of approximately 1300 meters. Keathley Canyon exhibits a deep (250 to 500 meters sub-seafloor), pronounced regional bottom simulating reflector (BSR), a notable geologic and geophysical barrier between free Previous HitgasNext Hit and solid hydrate. The BSR is bounded to the east by a salt-produced fault ridge, which is also a probable fluid migration pathway. The BSR has reverse polarity relative to the water bottom interface and obliquely cuts stratigraphic reflections. In some areas the BSR is also defined by periodic, high amplitude terminations of free Previous HitgasNext Hit in the coarser-grained, interbedded sands below. The Atwater Valley study area is located in the middle of the Mississippi Canyon and contains numerous hydrate mound features. Most mounds show strong seismic evidence of Previous HithydratesNext Hit including Previous HitgasNext Hit chimneys, amplitude blanking, and near-seafloor BSRs. Beginning in 2004, drilling through the Previous HitgasNext Hit hydrate zone within these two areas, for research purposes, will test these ideas of hydrate occurrences. The complexity and diversity of all these hydrate occurrences clearly drives the need for a cross-disciplinary approach.

 

uAbstract

uFigure captions

uGeneral statement

uKeathley Canyon

uAtwater valley

uConcluding remarks

uAcknowledgments

uReferences

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

uAbstract

uFigure captions

uGeneral statement

uKeathley Canyon

uAtwater valley

uConcluding remarks

uAcknowledgments

uReferences

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

uAbstract

uFigure captions

uGeneral statement

uKeathley Canyon

uAtwater valley

uConcluding remarks

uAcknowledgments

uReferences

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

uAbstract

uFigure captions

uGeneral statement

uKeathley Canyon

uAtwater valley

uConcluding remarks

uAcknowledgments

uReferences

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Figure Captions

Figure 1. Known and estimated deepwater Previous HitgasNext Hit hydrate occurrences in the Gulf of Mexico.

Figure 2. A seismic section from the 3D PSTM volume with stratigraphic interpretation at Keathley Canyon showing the BSR and hydrate mound. (LST: low stand system track, HST: high stand system track, SB: sequence boundary, color code denotes relative hazard risk).

Figure 3. Keathley Canyon line from the 3D PSTM volume showing BSR interpreted along the terminations of high amplitude free Previous HitgasNext Hit within the sand-rich layers. Sand and shale are inferred from seismic amplitude analysis and known shallow stratigraphy of the GOM.

Figure 4. Atwater Valley water bottom reflectivity and shaded relief showing Previous HitgasNext Hit hydrate mounds B through F and structural features. Note mound “E” with possible Previous HitgasNext Hit vent or mud volcano. Dashed line indicates orientation of profiles in Figures 5 and 6.

Figure 5. Atwater Valley WesternGeco 3D PSTM line through mounds “D” and “F”.

Figure 6. Atwater Valley USGS 2D MCS high-resolution line through mounds “D” and “F”.

Return to top.

General Statement 

The northern deepwater Gulf of Mexico (GOM) contains many naturally occurring Previous HitgasNext Hit hydrate environments (Figure 1). Here and in other areas, hydrate concentrations, once viewed as a drilling safety hazard, are fast gaining attention as potential energy sources. The reason is simple: natural Previous HitgasNext Hit Previous HithydratesNext Hit, 99% of which exist in deep offshore marine basins (Makogan, 1997) are estimated to account for more than half of the total carbon content of the world’s known hydrocarbon resources (Kvenvolden, 1993), with 1 m3  of natural Previous HitgasNext Hit hydrate yielding approximately 164 m3 of CH4 methane (Collett, 1993).  

Finding and assessing areas of Previous HitgasNext Hit hydrate occurrence is therefore important, although not always straightforward. Traditionally, a bottom-simulating reflection (BSR), a strong thermobaric barrier and seismic impedance contrast between free Previous HitgasNext Hit and solid hydrate in sediment, has been used to delineate zones where Previous HitgasNext Hit Previous HithydratesNext Hit are likely present. In areas of the world where BSRs are evident on the seismic data, the spatial extent of Previous HitgasNext Hit Previous HithydratesNext Hit can be inferred with a high degree of confidence. The GOM, however, provides only a handful of documented regional BSR examples. This may be because the complex GOM lithostratigraphy and active salt movement create complicated thermal regimes and fluid chemistry. Also, low-permeability sediments in the shallow section inhibit free Previous HitgasNext Hit migration. These conditions will greatly affect hydrate formation, distribution, and seismic amplitude of the BSR. While the presence of a BSR is a prime indicator of hydrate occurrences, high-quality seismic data can provide a wide range of other indicators as well.  

In an effort to study and eventually drill different hydrate settings, two separate GOM deepwater areas were selected for review by a multidisciplinary team. Reprocessed 3D prestack time migrated data (PSTM) and high-resolution 2D multichannel seismic data (MCS) were analyzed over one Keathley Canyon (KC) block (195) and one Atwater Valley (AV) block (14), both of which are in water depths of approximately 1300 m.

 

Keathley Canyon 

A dominant feature in the KC area is a pronounced regional BSR about 250-500 m below the seafloor mudline (Figure 2). The BSR is bisected to the east by a salt-produced faulted ridge, which is also a probable fluid and Previous HitgasNext Hit migration pathway. The BSR has reverse polarity relative to the water bottom reflector and obliquely crosscuts stratigraphic events. In some areas, the BSR is also interpreted along high-amplitude terminations of free Previous HitgasNext Hit in the coarser-grained sediments immediately below the BSR (Figure 3). There may also be several seafloor hydrate mounds in close proximity to the fault ridge (e.g., right side of Figure 2).

 

Atwater Valley 

The Atwater Valley study area is located in the middle of the Mississippi Canyon paleo-channel system and contains numerous features interpreted to be hydrate mounds (Figure 4). Although no evidence of a regional BSR can be seen, most mounds show strong seismic indicators of Previous HithydratesNext Hit including Previous HitgasNext Hit chimneys, amplitude “wipe-out” zones, and near-seafloor reversed-polarity seismic waveforms. Figures 5 and 6 show a northwest-southeast-trending seismic traverse through mounds “D” and “F”, and illustrate two different hydrate mound types. A WesternGeco reprocessed 3D PSTM random line is shown in Figure 5 and the USGS high-resolution 2D MCS line of the same orientation is shown in Figure 6. The areas beneath both mounds reveal an amplitude disturbance within the upper 300 m of the section, free Previous HitgasNext Hit velocity anomalies and reverse polarity seismic events interpreted as shallow localized BSRs. However, the difference in depth of the BSR below each mound indicates dissimilarities and suggests something about the amount of hydrate present. For example, the very near-seafloor high-amplitude BSR at location “D” suggests that a hydrate crustal mound, possibly 60 m to 80 m in diameter, is exposed at the seafloor. It is probable that only free Previous HitgasNext Hit, and not hydrate, exists below this mound. The BSR at mound “F”, about 50 m below the surface, is better defined and deeper than at mound “D”. This indicates a different fluid-Previous HitgasNext Hit flux or chemical composition and probable thicker concentration of hydrate below the seafloor. As distance increases away from the center of the mound where the high flux is interpreted, the BSR plunges downward toward the deeper section with a bell-shaped geometry (Figure 5). This suggests rapid pressure-temperature-chemical re-equilibration with the surrounding sediment.

 

Concluding Remarks 

Natural Previous HitgasNext Hit hydrate occurrences within northern GOM deepwater areas are often complex and diverse. Differences in lithologic, thermal, and geochemical regimes can create variations in hydrate formation and concentration levels. In addition, the presence of low permeability, fine-grained sediments in the shallow section reduces Previous HitgasNext Hit migration except in proximity to fault or fracture systems. These and other factors serve to make seismic detection of Previous HithydratesNext Hit challenging. However, these two study areas have shown that high quality seismic data and detailed stratigraphic interpretation can be used to find and delineate Previous HitgasNext Hit hydrate concentrations, whether with the aid of a prominent BSR or by other distinctive hydrate characteristics. Drilling through the Previous HitgasNext Hit hydrate zone within these two areas in 2004, for research purposes, will test these ideas of hydrate occurrences.

 

Acknowledgements 

We thank Diana Gillespie, Adam Koesoemadinata, Lecia Muller, Dianna Shelander, Randy Utech, and Gary Wool for help with the project; we also thank WesternGeco and the USGS for the use of seismic data.

 

References 

Collett, T.S., 1993, Natural Previous HitgasNext Hit Previous HithydratesNext Hit of the Prudhoe Bay-Kuparuk River area, North Slope, Alaska: AAPG Bulletin, 77, p. 793-812.

Cook, D., and D’Onfro, P., 1991, Jolliet Field thrust fault structure and stratigraphy Green Canyon Block 184, offshore Louisiana: Transactions – Gulf Coast Association of Geological Societies, v. XLI, p. 100-121.

Cooper, A., and Hart, P., 2002, Seismic studies of the Previous HitgasNext Hit-hydrate stability zone, northern Gulf of Mexico: Proceedings of the Fourth International Conference on Previous HitGasNext Hit Previous HitHydratesNext Hit, Yokohama, May 19-23, p. 115-123.

Kvenvolden, K.A., 1993, Previous HitGasNext Hit Previous HithydratesNext Hit as a potential energy resource: a review of their methane content: Geological Survey Professional Paper U.S., 1570, p. 555-561.

Makogan, Y.F., 1997, Previous HitHydratesNext Hit of hydrocarbons: Pennwell Books, USA.

McConnell, D., and Kendall, B., 2003, Images of the base of Previous HitgasNext Hit hydrate stability in the deepwater Gulf of Mexico: Examples of Previous HitgasNext Hit hydrate traps in northwest Walker Ridge and implications for successful well planning: The Leading Edge, April.

Milkov, A., 2000, Worldwide distribution of submarine mud volcanoes and associated Previous HitgasNext Hit Previous HithydratesNext Hit: Marine Geology, v.167, p. 29-42.

Milkov, A., Sassen, R., 2002, Resources and economic potential of individual Previous HitgasNext Hit hydrate accumulations in the Gulf of Mexico continental slope: Marine and Petroleum Geology, November review, 45 p.

Weimer, P., and Dixon, B., 1994, Regional sequence stratigraphic setting of the Mississippi fan complex, northern deep Gulf of Mexico: Implications for evolution of the northern gulf basin margin: GCSSEPM Foundation 15th Annual Research Conference Submarine Fans and Turbidite Systems, December, p. 373-381.

Wood, W., Gettrust, J., Chapman, N., Spence, G., and Hyndman, R., 2002, Decreased stability of methane Previous HithydratesTop in marine sediments owing to phase-boundary roughness: Nature, v. 420, p. 656-660.

Wood, W. T., Stoffa, P.L., and Shipley, T.H., 1994, Quantitative detection of methane hydrate through high-resolution seismic velocity analysis: Journal of Geophysical Research, 99, p. 9681-9695.

 

Return to top.