[First Hit]

Datapages, Inc.Print this page

  Click to view article in PDF format.

 

GCRocky Mountain Subthrust Exploration Using Pre-Stack Depth Previous HitMigrationNext Hit*

By
Mary Sue Purcell1, Steven G. Siguaw2, and Steven G. Natali3
 
Search and Discovery Article #40118 (2004)
 
*Adapted from the Geophysical Corner column in AAPG Explorer, September, 2003, entitled “Where Should We Put the Drill Bit?,” and prepared by the authors. Appreciation is expressed to them, to R. Randy Ray, Chairman of the AAPG Geophysical Integration Committee, and to Larry Nation, AAPG Communications Director, for their support of this online version.
 
1Geophysicist, Samson Resources, Denver; CO ([email protected])
2Geophysicist, Cabot Oil & Gas, Denver; CO ([email protected])
3Exploration director, Williams Production RMT, Denver, CO ([email protected])

 

General Statement 

In the Rockies we are all looking for a hidden structure that will discover a new big gas field. In 1994, Barrett Resources (now Williams Production Company) made a significant Rocky Mountain gas discovery at Cave Gulch Field, with reserves in excess of 600 BCF. The field, located in the eastern half of Wyoming’s Wind River Basin, produces from multiple stacked sandstone plays.

 

Following the initial discovery well, Barrett acquired a Previous Hit3-DNext Hit seismic survey that proved essential in determining the proper structural placement of subsequent development wells. Due to strong lateral velocity variations associated with the Owl Creek Thrust, the use of post-stack depth Previous HitmigrationNext Hit was mandatory to resolve the correct subsurface structure. (Natali et. al., 2000).

 

 

uGeneral Statement
uFigure captions
uExploration, Owl Creek thrust
  uSeismic
  uExploratory well
uConclusion
uReference

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

uGeneral Statement
uFigure captions
uExploration, Owl Creek thrust
  uSeismic
  uExploratory well
uConclusion
uReference

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

uGeneral Statement
uFigure captions
uExploration, Owl Creek thrust
  uSeismic
  uExploratory well
uConclusion
uReference

 

 

 

 

Figure and Table Captions

Figure 1. Location of the Boone Dome Previous Hit3-DNext Hit survey in the eastern Wind River Basin of Wyoming. 

Figure 2. North-south traverse through the Previous Hit3-DNext Hit survey, post-stack Previous HittimeNext Hit Previous HitmigrationNext Hit. Note how subthrust reflectors appear to dip southward toward the basin, and the absence of roll into the fault below the Clark Ranch Thrust.

Figure 3. North-south traverse through the Previous Hit3-DNext Hit survey (same as in Figure 2), pre-stack depth Previous HitmigrationNext Hit. Note how subthrust reflectors roll into the fault, forming a closed subthrust structure.

 

Click to view sequence of Figures 2 and 3.

Figure 4. Sub-sea depth map, Tensleep Formation, interpreted from the pre-stack depth Previous HitmigrationNext Hit volume. North-south seismic line traverse A-A’ is line for section in Figures 2 and 3.

Return to top.

 

Exploration along Owl Creek Thrust

 Seismic 

Building on its success along the Owl Creek Thrust, Williams partnered with Cabot Oil and Gas and caused them to acquire in 2001 the 118.5-square-mile Boone Dome Previous Hit3-DNext Hit survey (Figure 1). The center of the survey is located approximately 15 miles southeast from the Cave Gulch Previous Hit3-DNext Hit survey along the Owl Creek Thrust trend.

 

Survey parameters are:

  • Fold: 36 nominal.

  • CDP Bins: 110 feet x 110 feet.

  • Source: 8 Vibroseis trucks.

  • Recording patch size: 9,240 feet x 35,420 feet.

 

The preliminary Previous Hit3-DNext Hit interpretations, based on conventional Previous HittimeNext Hit-processed data, indicated the presence of numerous anticlinal folds in subthrust positions throughout the survey. One such area was the Wyatt Draw prospect, a three-way Previous HittimeNext Hit closure positioned along the Clark Ranch thrust, east of the main Owl Creek fault. 

Figure 2 shows a north-south traverse from the Previous HittimeNext Hit-processed Previous Hit3-DNext Hit survey. Along the thrust, Precambrian granite is juxtaposed against shales of the Triassic Chugwater formation. Granite interval velocities in this area are as high as 19,000 feet per second, while subthrust Chugwater velocities can be as low as 12,000 feet per second. This significant lateral velocity variation severely distorts the Previous HittimeNext Hit-migrated image below the thrust fault.  

To further evaluate the prospective structure, velocity analysis and depth processing of the seismic data were needed. The decision was made to utilize both pre-stack and post-stack depth Previous HitmigrationNext Hit techniques. Once the velocity field is properly accounted for, an accurate depth image of the subsurface can be achieved. 

Figure 3 shows the pre-stack depth Previous HitmigrationNext Hit of the same Previous Hit3-DNext Hit traverse as in Figure 2. There is a notable difference between the two sections, especially along the footwall portion of the Clark Ranch Thrust. By properly accounting for the high velocities associated with the granite and the Lower Paleozoic rocks in the hanging wall, the structure is now correctly imaged. Instead of having a subthrust nose lacking north dip, the Wyatt Draw prospect now as mapped has four-way closure. This closure also was evident on the post-stack depth Previous HitmigrationNext Hit, although the image was of lower quality than the pre-stack depth volume.

 

Exploratory Well 

Based on the results of the pre-stack depth Previous HitmigrationNext Hit, a wildcat well was drilled by Cabot and Williams during the summer of 2002. The Williams #31-2 Wyatt Draw well, Section 2, T35N, R85W, Natrona Country, Wyo., was located to take advantage of the footwall structural crest for both the Tensleep Sandstone and Madison carbonate formations. Both are prolific producers in other parts of the Wind River Basin, as well as other basins in the Rockies. 

The well was deviated due to unfavorable surface conditions above the preferred target at depth, and drilling plans involved minimizing the amount of granite that needed to be drilled in the hanging wall. While drilling, formation tops came in very close to prognosis for both the hanging wall and footwall; these predictions were based on the pre-stack depth seismic volume combined with area well control (Figure 4).  

A dipmeter obtained in the well indicated the presence of critical north dip below the main thrust, and also that the bottom-hole location was near the top of the structure. A velocity check shot survey was obtained and used to create a final pre-stack depth migrated image. The crestal position of the structure moved very little, and the final depth calibration was changed by only 15 feet, confirming the quality of the original depth processing. 

The #31-2 Wyatt Draw wildcat was not a commercial discovery, despite finding a closed subthrust structure. Log analysis indicated marginal oil saturations and generally reduced porosities in both the Tensleep and Madison reservoirs.

 

Conclusion 

Three-D seismic data, in combination with modern pre-stack depth Previous HitmigrationNext Hit techniques, can be used satisfactorily to image complexly thrusted structures, and can place a drill bit in a favorable structural location with a relatively high degree of certainty. Three-D seismic depth imaging opens the door for future exploration along basin-bounding faults in other Rockies basins.

 

Reference 

Natali, S.G., R. Roux, P. Dea, and F. Barrett, 2000, Cave Gulch Previous Hit3-DNext Hit survey, Wind River basin, Wyoming, in R.R. Ray and M.W. Longman, eds., Previous Hit3-DTop seismic success stories in the Rocky Mountain region: The Mountain Geologist, v. 37, p. 3-13.

 

 Return to top.