--> Abstract: Coupled Reservoir Simulation and Finite-Element Modeling of Shear Failure Potential on Reservoir Boundary Faults in the Lower Tertiary (Paleogene) Plays in the Gulf of Mexico, by Brown, Jeremy A.; Zoback, Mark; Hornby, Brian; and Stauber, Doug; #90166 (2013)
[First Hit]

Datapages, Inc.Print this page

Coupled Previous HitReservoirNext Hit Previous HitSimulationNext Hit and Finite-Element Previous HitModelingNext Hit of Shear Failure Potential on Previous HitReservoirNext Hit Boundary Faults in the Lower Tertiary (Paleogene) Plays in the Gulf of Mexico

Brown, Jeremy A.1; Zoback, Mark; Hornby, Brian; and Stauber, Doug
1[email protected]

The ultra-deepwater lower Tertiary plays of the Gulf of Mexico, also known as the Paleogene, are HPHT reservoirs that will require cutting-edge technology to be successfully produced. In this study we report a coupled Previous HitreservoirNext Hit-geomechanical Previous HitsimulationNext Hit analysis used to model potential stress changes due to Previous HitreservoirNext Hit depletion and potential shear failure on pre-existing faults.

A geomechanical model has been developed that constrains the overburden stress, the minimum horizontal stress, rock properties from available lab tests on core, and pore pressure. Constraining the maximum horizontal stress is difficult based on available data. Given that the Previous HitreservoirNext Hit is severely overpressured in a normal faulting environment, several realizations were generated where the maximum horizontal stress lies between the minimum horizontal stress and overburden stress. The orientations of the horizontal stresses have been estimated from the orientation of active faults in the area.

Two idealized Paleogene structural models were built with the primary Previous HitreservoirNext Hit sands lying beneath large salt bodies. A Previous HitreservoirNext Hit grid was created and populated with known Previous HitreservoirNext Hit properties. Realistic primary recovery fluid-flow Previous HitreservoirNext Hit simulations were performed in a commercial Previous HitreservoirNext Hit simulator with the resulting fluid pressure changes over the life of the Previous HitreservoirNext Hit being transferred to the finite-element geomechanical simulator (ABAQUS) to update porosity, permeability, and deformational changes in the Previous HitreservoirNext Hit. Based on earlier work, we seek to confirm that, given substantial depletion, fault re-activation is likely to occur for a given stress path. Depending on the amount of depletion and the magnitude of the maximum horizontal stress, shear failure is possible on the bounding faults that compartmentalize the Paleogene Previous HitreservoirTop. These results have implications on well placement and pressure management of the field.

 

AAPG Search and Discovery Article #90166©2013 AAPG International Conference & Exhibition, Cartagena, Colombia, 8-11 September 2013