--> ABSTRACT: Origin of High Porosity Zones in Mid-Deep Buried Paleogene Clastic Reservoirs in Dongying Sag, East China, by Yuan, Guanghui; Cao, Yingchang ; Zhang, Shanwen; Wang, YanZhong; Wang, Shuping; #90142 (2012)
[First Hit]

Datapages, Inc.Print this page

Origin of High Previous HitPorosityNext Hit Zones in Mid-Deep Buried Paleogene Clastic Reservoirs in Dongying Sag, East China

Yuan, Guanghui *1; Cao, Yingchang 1; Zhang, Shanwen 2; Wang, YanZhong 1; Wang, Shuping 3
(1) School of Geosciences, China University of Petroleum ( East China ), Qingdao, China.
(2) Shengli Oilfield, SINOPEC, Dongying, China.
(3) Geological Science Research Institute of Shengli Oilfield, SINOPEC, Dongying, China.

Three anomalously high Previous HitporosityNext Hit zones (porosity>20%) developed in the middle (2500m-3500m) and deep (>3500m ) buried Paleogene subaqueous fan and sublacustrine fan clastic reservoirs in 2800m-3050m (max Previous HitporosityNext Hit=29.5%), 3300m-3600m (max Previous HitporosityNext Hit=28.1%), and 3900m-4200m (max Previous HitporosityNext Hit=22.3%), respectively, in Shengtuo area, Dongying sag, East China. It is still debatable whether mid-deep buried high Previous HitporosityNext Hit zones are an inheritance of shallow high Previous HitporosityNext Hit reservoirs whose primary Previous HitporosityNext Hit is well preserved in deep burial stage, or are developed through mineral dissolution in the mid-deep buried low Previous HitporosityNext Hit reservoirs. Compaction and multi-stage Previous HitcarbonateNext Hit cementation are main factors that reduced reservoir Previous HitporosityNext Hit, while primary Previous HitporosityNext Hit is on large extent preserved. Fluid overpressure began to develop approximately 41Ma and 16Ma ago when reservoir depth was about 2000m. Reservoir with hyperpressure has 6-8% more Previous HitporosityNext Hit than normal pressure reservoir, so the fluid overpressure largely slowed down the compaction during deep burial stage. Maximum oil expulsion occurred during 39-31.9Ma and 13-0Ma, respectively. Statistics show that oil immersion sandstones have 4-6% fewer Previous HitcarbonateNext Hit cements than sandstones with oil trace or fluorescence, indicating that early hydrocarbon emplacement impeded Previous HitcarbonateNext Hit cementation significantly. Also, a mass of feldspars were found dissolved while Previous HitcarbonateNext Hit debris and Previous HitcarbonateNext Hit cements were left intact which might due to a relative high partial pressure of carbon dioxide (pCO2) or Ca2+ concentration in Previous HitformationNext Hit fluids. However, feldspar dissolution hardly enhanced the reservoir Previous HitporosityNext Hit. The author found almost isovolumetric dissolution products precipitated in the nearby primary intergranular pores, in forms of authigenic kaolinite (D<3100m, T<125°C), authigenic illite (D>3100m, T>125°C) and quarts overgrowths due to an absence of favorable fluid migration pathways in relatively closed diagenetic environment, net enhanced Previous HitporosityNext Hit originated from feldspar dissolution is generally less than 0.25%. Consequently, shallow development of fluid overpressure and early hydrocarbon emplacement are the two controlling factors for development of the three high Previous HitporosityNext Hit zones. Thus favorable exploration targets should be reservoirs with good primary Previous HitporosityNext Hit that experienced fluid overpressure developed from shallow, early hydrocarbon emplacement (before 1st Previous HitcarbonateNext Hit cementation), and good Previous HitpreservationTop during later burial.

 

AAPG Search and Discovery Article #90142 © 2012 AAPG Annual Convention and Exhibition, April 22-25, 2012, Long Beach, California